SD Ramps Breakout for RAMPS

SD Ramps Breakout for RAMPS

Product Code:xiaolu028
Availability:In Stock
  • $8.00

  • Ex Tax: $8.00
This product has a minimum quantity of 6

Ever wanted to run your RepRap from SD card? Here is your chance! This RAMPS add-on enables you to print from MicroSD.With RAMPS 1.3 and higher it's easily connected to the RAMPS board.

 

Features:

SPI mode

Support voltage:4.5 to 5.5V

Up to 50 MB/sec data transfer rate

Sits directly on a RAMPS

Also be used with other microcontrollers

 

Documents:

SD commands G-code

Sprinter firmware

 

For more information,please check our WIKI Page

 

Write a review

Note: HTML is not translated!
    Bad           Good